Home » Categories » Multiple Categories

Bucket water feature DIY

A bucketful of water

This small water feature is simple to make and will add the sensory element of running water to a special spot in your garden

What you need
•1 x 20l galvanized bucket with a sturdy handle
•1 x 1m length 15mm copper plumbing pipe
•1 old garden tap.
•2 x 90 degree elbows
•1 tap connection fitting
•1 small tube of silicon water-proof sealer.
•1 hose clamp
•2 half-round wall-mount brackets
•Fencing wire.
•Pliers
•1 short length of 15mm clear tubing
 
 

What you do
1.Measure from the base of the bucket to the height that you want the tap to be above the bucket. Cut a piece of copper pipe to this length.
2.Fasten the 90 degree elbows to each end of this piece of pipe.
3.Cut two short pieces of copper pipe (about 50mm) and add them to the pipe elbows on each end.
4.Fit the tap onto one of these extension pieces.
5.In the base of the bucket, drill a hole of 15mm, about 5mm from the edge, for the plumbing fitting.
6.Drill a second smaller hole, to the left of the first 15mm hole, for the electric cable.
7.If you plan on mounting the feature to a wall, then use the wall mount brackets to secure the pipe against the wall before continuing with the installation of the plumbing onto the bucket.
8.Insert the bottom end of the plumbing fitting (the end without the tap) into the hole and silicone it closed so that it is water-tight.
9.Fit the clear tubing to the other side of the pipe and fasten it with a hose clamp.
10.Fasten the plumbing pipe to the bucket, at the desired angle, with fencing wire.
11.Install the pump in the bucket and connect it to the clear tubing.
12.Fill the bucket three quarters full with water. Turn the pump on and observe the water level in the bucket. Top it up as required. Be aware that this feature will lose water over time owing to evaporation and splash loss, so check it regularly to make sure it does not run dry.

Information supplied by KLB Engineering on 011 668 1923 or visit www.klbengineering.com. The water feature was installed by Craig de Necker of The Friendly Plant, in association with KLB Engineering. Contact Craig on 082 805 0910 or visit www.thefriendlyplant.co.za

Attachments Attachments
There are no attachments for this article.
Comments (1) Comments
Comment by garden decorations on Wed, Aug 14th, 2013 at 10:21 AM
Informative post!! Thank you for the wonderful share!! http://www.home2garden.co.uk/
Related Articles RSS Feed
Bamboo water feature DIY
Viewed 12361 times since Wed, Oct 24, 2012
Quick and easy water feature DIY
Viewed 12115 times since Mon, Oct 22, 2012
Fired up - making a portable fire
Viewed 9978 times since Fri, Sep 28, 2012
Revamping an outdoor entertainment braai area
Viewed 8594 times since Thu, Aug 30, 2012
Recycled Wine Bottle Torch
Viewed 41564 times since Thu, Aug 29, 2013
Watering can makeover
Viewed 4758 times since Wed, Apr 4, 2012
Build a pond
Viewed 12435 times since Fri, Sep 7, 2012
Creating space
Viewed 3159 times since Fri, Aug 24, 2012
Quick DIY: Trendy Planter
Viewed 13620 times since Thu, Aug 29, 2013
Build an outdoor shower
Viewed 10565 times since Thu, Mar 14, 2013